Field data proves GaN FET reliability, says EPC

Gallium nitride power FET maker Efficient Power Conversion (EPC) has published its reliability report documenting GaN technology reliability after millions of device hours of stress testing, and based on analysis of all field returns.

EPC’s Phase Eight Reliability Report documents a combined total of over 8 million GaN device-hours with zero failures. The report examines, in detail, the stress tests that EPC devices are subjected to prior to release as qualified products and analyzes the physics of failure.

In this report, product-specific detailed stress test results for over millions of actual device hours are provided. In addition to product qualification stress testing, due diligence is necessary in other areas of reliability such as field experience, failures over device operational lifetime, and board level reliability.

As part of the report, EPC examined all devices returned by its customers, as ‘field failures’; the company says says it has received a total of 127 products returned by customers; of those, it could not find any fault with 37, leaving 90 to be the subject of in-service failure analysis. 75 units were found to have failed due to assembly problems. To achieve very low inductances, EPC uses a chipscale packaging format with solder ball connections; an example failure mode was found to be that poor surface-mount technology had caused problems – for example, incomplete solder flux removal had led to the formation of dendrites (metallic ‘whiskers’) around the solder terminations.

In several other cases – almost all of the remaining failures – EPC’s engineers determined that the circuitry surrounding the GaN device had not been designed with sufficient attention to low inductances to match those of the device packaging. It is well documented that GaN FETs switch extremely fast: in these cases EPC found that the voltage transients, and ringing, generated had exceeded the absolute max values of the FETs.

Gallium nitride power FET maker Efficient Power Conversion (EPC) has published its reliability report documenting GaN technology reliability after millions of device hours of stress testing, and based on analysis of all field returns.

More specifically, the three sections of tests covered in this Phase Eight Reliability Report are:

I: Field Reliability Experience

Field Failures Examined

Assembly Failures

Applications Failures

Intrinsic Die Qualification

II: Early Life Failure and Wear-out Capability

Early Life Failure Rate

Electromigration

III: Board Level Reliability and Thermo-mechanical Capability

Intermittent Operating Life

Temperature Cycling

Board-Level Reliability

This report, coupled with the field reliability of eGaN FETs and ICs given in the Phase Seven Reliability Report, which documented the accumulation of over 17 billion device operation hours combined with a very low failure rate below 1 FIT (failures per billion hours), demonstrates that the stress-based qualification testing is capable of ensuring reliability in customer applications. The cumulative reliability information compiled, EPC concludes, shows that eGaN FETs and ICs have solid reliability and are able to operate with very low probability of failures within reasonable lifetimes of end products manufactured today.

According to Dr. Alex Lidow, CEO and co-founder of EPC, “Demonstration of the reliability of new technology is a major undertaking and one that EPC takes very seriously. The tests described in this report, along with the reported results, show that EPC gallium nitride products have the requisite reliability to displace silicon as the technology of choice for semiconductors.”

http://www.electronics-eetimes.com/news/field-data-proves-gan-fet-reliability-says-epc-0

 

Contact Us

We're not around right now. But you can send us an email and we'll get back to you, asap.

Not readable? Change text.

Start typing and press Enter to search